Solidscape 3D Printer Supplies

CadBlu offers a complete line of Solidscape materials and parts. If you don't see what you need here, contact us!

	Solidscape InduraFill (Support) 500ml Bottle, Granules Composition: natural and synthetic waxes and fatty esters. Melting point: 120°-158°F (49°-70°C). Soluble in a mineral oil bath at 140°-150°F (60°-65°C). No post-dissolve dry or cure time. No post-dissolve finishing or touch up necessary. Non-toxic.

	Solidscape InduraCast (Build) 500ml Bottle, Granules Composition: thermoplastic. Melting point: 203°-230°F (95°-110° C). Co-efficient of thermal expansion (CTE): negligible. Residue after autoclave process: None No shrinkage, distortion, disintegration at normal temperatures. Non-toxic.

	Solidscape VSO BIOACT, 5 Gallons The support material is removed from the final finished model by immersing the model and attached support material that was removed from the InduraBase into a heated, thermostatically controlled bath of BIOACT VSO solvent. The wax support material dissolves in VSO and exposes the actual model. The time required for the wax to dissolve is dependent on several factors including the model and wax geometry, the temperature of the bath and the concentration of the solvent. Fresh solvent is most effective. Old solvent with a high concentration of dissolved support material should be discarded in accordance with local waste disposal regulations.

	Solidscape VSO BIOACT, 1 Gallon The support material is removed from the final finished model by immersing the model and attached support material that was removed from the InduraBase into a heated, thermostatically controlled bath of BIOACT VSO solvent. The wax support material dissolves in VSO and exposes the actual model. The time required for the wax to dissolve is dependent on several factors including the model and wax geometry, the temperature of the bath and the concentration of the solvent. Fresh solvent is most effective. Old solvent with a high concentration of dissolved support material should be discarded in accordance with local waste disposal regulations.

	Solidscape Calibration Tape Roll This 1" wide Solidscape Paper Tape Roll is used in the calibration process

	Solidscape InduraBase Build Plate D76 Standard Size Build InduraBase for building Solidscape parts.

	Solidscape Vacuum Filter Bags 4 pack, Electrolux EL202B S-Bag Solidscape Vacuum Filter bags.

	Solidscape Purge Tubing Purge tube is sold by the foot. Enter the quantity of continuous amount of tube length needed

	Purge Syringe for Solidscape printers The Purge Syringe will help all Solidscape models make an air bubble in the jet that acts as a damper so the material is dispensed correctly.

	Solidscape Purge Spout Cap For capping off the purge spout.

	Solidscape Purge and Discharge Tubes - 3 pack D76 Solidscape Purge and Discharge Tubes are used for catching excess material when purging. Available as 3 units per pack.

	Solidscape Cutter Cleaning Brush Comfortable wood handle with synthetic bristles for long lasting use. Used to clean excess material from the cutting blade on all Solidscape models.

	Solidscape Tank Dipstick Constructed of solid aluminum with measurment markings, the dipsticks are used to check the level of the fluid tanks. One is required for each tank in order to prevent contamination of materials.

	Solidscape Waste Tray D76 The Solidscape Replacement Waste Tray Sits under the paper feeder and will catch excess material.

	Solidscape Touch Screen Stylus The Solidscape Touch screen stylus is used to makes selections and enter input on the D76 model.